Access Point Factory Reset

Occasionally, firmware upgrade instructions or Luxul support staff may direct you to restore an access point to factory defaults. The following instructions cover three different ways to reset an AP, depending on whether your AP is managed by a Wireless Controller or is standalone.

Wireless Controller Managed

  1. Use your browser to log in to your Wireless Controller’s configuration interface (usually 192.168.0.19).

  2. Select Profile Management > AP Assignment if that page isn’t already loaded.

  3. Select the AP you’d like to reset to factory defaults from the column on the right.

  4. Select Remove to unassign the AP.

  5. Select Save to reset the AP to factory default.

    Note: You MUST select Save for the factory reset process to complete.

  6. WAIT TWO MINUTES for the AP(s) to reset to factory defaults.

  7. Select Profile Management > AP Assignment.

  8. Select the AP you removed from the column on the left.

  9. Select Add, then select Save to re-add the AP to the Profile.

Standalone

Configuration Interface

  1. Use your browser to log in to your AP’s configuration interface (usually 192.168.0.10 or 192.168.0.16).

  2. Select Administration > Factory Defaults from the navigation menu.

  3. Select Reset to restore factory defaults. The AP will reset to factory defaults and reboot with a self-assigned IP address of 192.168.0.10 or 192.168.0.16 (depending on the AP model).

  4. Reconfigure the AP as desired.

Reset Button

  1. Press and hold the Reset button located on the back of the AP for approximately 10 seconds. Once the button is released, the AP will reset to factory defaults and reboot with a self-assigned IP address of 192.168.0.10 or 192.168.0.16 (depending model the model of AP).

  2. Reconfigure the AP as desired.