Default IP and Factory Reset Instructions

Below you can find the default IP and Factory reset instructions for Luxul products.

Product SKU       

Default IP for Device

Factory Reset Instructions
XWR-3150 192.168.0.1 To Restore the Default Settings: With the router powered on (indicated by a green LED under the power icon (IMG)), press and hold the 'RESET' button (located on the rear panel) with a paperclip or similar object until the LED under the system icon (IMG) begins to flash rapidly (approximately 5 seconds), then release the button. The system LED will flash rapidly, then turn off, then begin blinking rhythmically as the device restores its default configuration and reboots. When the system LED flashes like a heartbeat, the device has been reset to factory defaults and is ready for use. PLEASE NOTE: A factory reset may take approximately 1 minute to complete, and upon completion, the software version will not change.
XWR-1200  192.168.0.1 To Restore the Default Settings: With the router powered on (indicated by a green LED under the power icon (IMG)), press and hold the 'RESET' button (located on the rear panel) with a paperclip or similar object until the LED under the system icon (IMG) begins to flash rapidly (approximately 5 seconds), then release the button. The system LED will flash rapidly, then turn off, then begin blinking rhythmically as the device restores its default configuration and reboots. When the system LED flashes like a heartbeat, the device has been reset to factory defaults and is ready for use. PLEASE NOTE: A factory reset may take approximately 1 minute to complete, and upon completion, the software version will not change.   
XAP-1410  192.168.0.10 To Restore the Default Settings: With the access point powered on (indicated by the green LED on the front of the AP), press and hold the 'RESET' button (located underneath the mount) until the green LED flashes rapidly (approximately 5 seconds), then release the button. The green LED will flash rapidly, then turn off, then begin blinking while the access point restores its default configuration and reboots. When the green LED comes back on, the access point is set to factory default and is ready for use. 
XAP-810  192.168.0.10 To Restore the Default Settings: With the access point powered on (indicated by the green LED on the front of the AP), press and hold the 'RESET' button (located underneath the mount) until the green LED flashes rapidly (approximately 5 seconds), then release the button. The green LED will flash rapidly, then turn off, then begin blinking while the access point restores its default configuration and reboots. When the green LED comes back on, the access point is set to factory default and is ready for use.